The Site To Site Vpn Add/Edit Screen- Wizard - ZyXEL Communications USG FLEX H Series User Manual

Figure 120 VPN > Site to Site VPN
Each field is discussed in the following table.
Table 85 Configuration > VPN > IPSec VPN > VPN Connection
LABEL
Global Setting
Add
Edit
Remove
Active
Inactive
Connect
Disconnect
Status
Name
Outgoing
Interface
Remote
Gateway
Type
Local
Remote
Config Type
Apply
Reset

11.3.1 The Site to Site VPN Add/Edit Screen- Wizard

The Site to Site VPN Add/Edit Gateway screen allows you to create a new VPN connection policy or edit
an existing one. To access this screen, go to the VPN > Site to Site VPN screen, and click either the Add
icon or an Edit icon. Select Site-to-Site in VPN > Site to Site VPN> Add/Edit > Scenario > Type to create a
VPN rule using the wizard.
Chapter 11 IPSec VPN
DESCRIPTION
The following two fields are for all IPSec VPN policies.
Click this to create a new entry.
Double-click an entry or select it and click Edit to open a screen where you can modify the
entry's settings.
To remove an entry, select it and click Remove. The Zyxel Device confirms you want to remove it
before doing so.
To turn on an entry, select it and click Activate.
To turn off an entry, select it and click Inactivate.
To connect an IPSec SA, select it and click Connect.
To disconnect an IPSec SA, select it and click Disconnect.
The activate (light bulb) icon is lit when the entry is active and dimmed when the entry is
inactive.
The connect icon is lit when the interface is connected and dimmed when it is disconnected.
This field displays the name of the VPN rule.
This field displays the interface IP address or DNS name the VPN connection uses to transmit
packets.
This field displays the remote IPSec device IP address or DNS name in use for this VPN
connection.
This field displays the type (route based or policy based) the VPN rule is using.
This field displays the IP address of the computer on your network.
This field displays the IP address of the computer behind the remote IPSec device.
This field displays if the VPN rule is configured through wizard or a customized rule.
Click Apply to save your changes back to the Zyxel Device.
Click Reset to return the screen to its last-saved settings.
USG FLEX H Series User's Guide
168