Tftp Command Configuration Backup Example; Configuration Backup Using Gui-Based Tftp Clients; Using Ftp Or Tftp To Restore Configuration; Table 122 General Commands For Gui-Based Tftp Clients - ZyXEL Communications Network Device P-2602 User Manual

802.11g wireless adsl2+ voip iad/adsl2+ voip iad
Table of Contents

Advertisement

P-2602H(W)(L)-DxA Series User's Guide

25.7.5 TFTP Command Configuration Backup Example

The following is an example TFTP command:
where "
" specifies binary image transfer mode (use this mode when transferring binary files),
i
"
" is the ZyXEL Device IP address, "
host
(
, name of the configuration file on the ZyXEL Device) to the file destination on the
rom-0
computer and renames it config.rom.

25.7.6 Configuration Backup Using GUI-based TFTP Clients

The following table describes some of the fields that you may see in GUI-based TFTP clients.

Table 122 General Commands for GUI-based TFTP Clients

COMMAND DESCRIPTION
Host
Send/Fetch
Local File
Remote File This is the filename on the ZyXEL Device. The filename for the firmware is "ras" and for
Binary
Abort
Refer to
Section 25.3 on page 302
over WAN.

25.8 Using FTP or TFTP to Restore Configuration

This section shows you how to restore a previously saved configuration. Note that this
function erases the current configuration before restoring a previous back up configuration;
please do not attempt to restore unless you have a backup configuration file stored on disk.
FTP is the preferred method for restoring your current computer configuration to your device
since FTP is faster. Please note that you must wait for the system to automatically restart after
the file transfer is complete.
310
tftp [-i] host get rom-0 config.rom
Enter the IP address of the ZyXEL Device. 192.168.1.1 is the ZyXEL Device's default IP
address when shipped.
Use "Send" to upload the file to the ZyXEL Device and "Fetch" to back up the file on your
computer.
Enter the path and name of the firmware file (*.bin extension) or configuration file (*.rom
extension) on your computer.
the configuration file, is "rom-0".
Transfer the file in binary mode.
Stop transfer of the file.
to read about configurations that disallow TFTP and FTP
" transfers the file source on the ZyXEL Device
get
Chapter 25 Tools

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents