Installing As A Rack-Mounted Unit; Panel Descriptions - Cisco CSS11501S-C-K9 Configuration Manual

Chapter 2 Installing the Hardware and Software

Installing as a Rack-Mounted Unit

Warning

Panel Descriptions

78-13124-06
To prevent bodily injury when mounting or servicing this unit in a
rack, you must take special precautions to ensure that the system
remains stable. The following guidelines are provided to ensure
your safety: 1) This unit should be mounted at the bottom of the rack
if it is the only unit in the rack. 2) When mounting this unit in a
partially filled rack, load the rack from the bottom to the top with
the heaviest component at the bottom of the rack. 3) If the rack is
provided with stabilizing devices, install the stabilizers before
mounting or servicing the unit in the rack.
Before you begin, you will need the mounting brackets and six screws shipped
with the Secure Content Accelerator, a #2 Phillips screwdriver, rack-mounting
screws and an appropriate screwdriver.
Position the Secure Content Accelerator with the front panel facing you.
1.
Position a mounting bracket on one side of the chassis, aligning the holes in
2.
the bracket with the screw holes on the chassis.
Secure the bracket to the chassis with three screws and the Phillips
3.
screwdriver.
Repeat steps 2 and 3 to install a mounting bracket on the other side of the
4.
chassis.
5. Raise the Secure Content Accelerator to the installation height. Align the
screw holes of the mounting brackets with the holes on the equipment rack.
6. Use the appropriate screwdriver and screws to secure each mounting bracket
to each side of the rack.
The front panel of the Secure Content Accelerator, shown in Figure 2-1, contains
the following connectors, switches, and LEDs:
Two DB9 serial ports, marked "AUX" and "CONSOLE"
•
• Two RJ-45 10/100 Ethernet interface ports, marked "SERVER" and
"NETWORK"
Cisco 11000 Series Secure Content Accelerator Configuration Guide
Panel Descriptions
2-5