Sslv3 Enable; Suspend - Cisco CSS11501S-C-K9 Configuration Manual

Configuration Command Set

sslv3 enable

Usage Guidelines
Related Commands

suspend

Syntax Description
Usage Guidelines
Cisco 11000 Series Secure Content Accelerator Configuration Guide
C-158
Enables SSL version 3 protocols.
sslv3 enable
no sslv3 enable
Availability: Serial, Telnet
Using the no form of the command disables SSL version 3 protocols. You cannot
disable SSL version 2 and 3 and TLS protocols. This command is not available in
FIPS mode.
sslv2 enable (Reverse-Proxy Server Configuration Command Set)
tlsv1 enable (Reverse-Proxy Server Configuration Command Set)
Suspends the function of the backend server.
suspend [now]
now
Availability: Serial, Telnet; FIPS Mode (serial only)
This command behaves in three ways:
If you are creating a new reverse-proxy server and you use the suspend
•
command, the server is created in the suspended state. No connections are
accepted until the activate command is used.
If you are editing an existing reverse-proxy server and you use the suspend
•
command alone, the all open connections on the server are finished, and no
new connections are accepted. No connections are accepted until the activate
command is used.
Suspends actions of the backend server immediately.
Appendix C Command Summary
78-13124-06