Configuring For Client-Side Access; Figure 5-1 Password Request Dialog Box - Cisco CSS11501S-C-K9 Configuration Manual

Chapter 5 Graphical User Interface Reference
Starting the GUI
Figure 5-1 Password Request Dialog Box
Note Before configuring a device in two-port mode from the client side
(via the "Network" port), you must first set up a secure server for this
purpose. See "Configuring for Client-Side Access".

Configuring for Client-Side Access

Use the commands below as an example to set up a secure server named web on
the Secure Content Accelerator, allowing GUI configuration from the client side
("Network" port).
myDevice> attach
myDevice> enable
myDevice# configure
(config[myDevice])> ssl
(config-ssl[myDevice])> server web create
(config-ssl-server[web])> ip address 127.0.0.1
(config-ssl-server[web])> sslport 443
(config-ssl-server[web])> remoteport 80
(config-ssl-server[web])> no transparent
(config-ssl-server[web])> cert default-1024
(config-ssl-server[web])> key default-1024
(config-ssl-server[web])> secpolicy all
(config-ssl-server[web])> finished
myDevice#
Cisco 11000 Series Secure Content Accelerator Configuration Guide
5-4
78-13124-06