Unpacking The Secure Content Accelerator; Installing The Hardware - Cisco CSS11501S-C-K9 Configuration Manual

Chapter 2 Installing the Hardware and Software

Unpacking the Secure Content Accelerator

Note

Installing the Hardware

Warning
78-13124-06
The Secure Content Accelerator is shipped in a protective carton. The appliance
is a self-contained chassis; no modules or components can be added or removed.
A tamper-evident sticker is affixed to the Secure Content
Accelerator. When using the device for FIPS-compliant operation,
this sticker must remain in place and untouched.
To unpack the Secure Content Accelerator:
1. Remove all enclosed packing materials. Save the packing materials in case
you need to repack the Secure Content Accelerator later.
2. Remove all accessories from the shipping carton.
3. Check the accessories against the items listed in the section "Shipment
Contents".
Before working on a system that has an on/off switch, turn OFF the
power and unplug the power cord. This unit has more than one
power cord. To reduce the risk of electric shock, disconnect the
two power supply cords before servicing the unit. The safety cover
is an integral part of the product. Do not operate the unit without
the safety cover installed. Operating the unit without the cover in
place will invalidate the safety approvals and pose a risk of fire
and electrical hazards.
The Secure Content Accelerator can be placed on a flat surface as a free-standing
unit or rack-mounted in an equipment cabinet. The following sections describe the
steps to install the Secure Content Accelerator as a:
Free-standing unit
•
Rack-mounted unit
•
Cisco 11000 Series Secure Content Accelerator Configuration Guide
Unpacking the Secure Content Accelerator
2-3