Cisco CSS11501S-C-K9 Configuration Manual page 98

Enabling Keepalives
The following example demonstrates enabling keepalives and configuring
settings.
1.
2.
3.
4.
5.
6.
7.
8.
Cisco 11000 Series Secure Content Accelerator Configuration Guide
4-30
Initiate a management session as described previously.
Enter Privileged, Configuration, and SSL Configuration modes.
SCA> enable
SCA# configure
(config[myDevice])# ssl
Enter Server Configuration mode for the desired server.
(config-ssl[myDevice])# server myServer
(config-ssl-server[myServer])#
Enable keepalive messaging.
(config-ssl-server[myServer])# keepalive enable
(config-ssl-server[myServer])#
Set the keepalive message frequency to 8 seconds and the failure interval to
5 non-responded keepalive messages.
(config-ssl-server[myServer])# keepalive frequency 8
(config-ssl-server[myServer])# keepalive maxfailure 5
(config-ssl-server[myServer])#
Verify the keepalive information by entering the info command.
(config-ssl-server[myServer])# info
...
Keepalive enable
Keepalive frequency
Keepalive maxfailure
...
Return to Privileged mode.
(config-ssl-server[myServer])# finished
SCA#
Save the configuration to flash memory. If not saved, the configuration is lost
during a power cycle or when the reload command is used.
SCA# write flash
SCA#
Chapter 4 Using the Configuration Manager
: on
: 8 seconds
: 5
78-13124-06