Supporting Snmp; Example: Configuring Snmp - Cisco CSS11501S-C-K9 Configuration Manual

Chapter 4 Using the Configuration Manager
Note

Supporting SNMP

Example: Configuring SNMP

78-13124-06
Enter the following command to generate a certificate using the key created
2.
in the previous example. An MD5 digest is displayed and the certificate is
saved in a file named myGenCert. (This command must be entered on one
line.) A wizard starts, requesting certificate information.
(config-ssl[myDevice])# gencsr key myGenKey digest md5 output
https://www.mywebsite.com/myGenCert
Using the HTTPS protocol ensures that your certificate is
transmitted securely.
Cisco Secure Content Accelerator devices have basic support for SNMP
functions. The device is shipped with SNMP disabled. This example demonstrates
how to set basic SNMP data.
Initiate a management session as described previously.
1.
Enter Privileged and Configuration modes.
2.
SCA> enable
SCA# configure
Enter SNMP data and enable SNMP. Access-list 1 has already been created.
3.
(See Appendix C for information for using the access-list command.) Return
to Privileged mode.
(config[myDevice])# snmp enable
(config[myDevice])# snmp access-list 1
(config[myDevice])# snmp location "Main Office"
(config[myDevice])# snmp contact "Administrator"
(config[myDevice])# snmp default community ITS_Office
(config[myDevice])# snmp trap-host v1 10.1.2.4
(config[myDevice])# snmp trap-type generic
(config[myDevice])# end
SCA#
Cisco 11000 Series Secure Content Accelerator Configuration Guide
Supporting SNMP
4-25