Working With Syslogs; Disabling Ssl Versions - Cisco CSS11501S-C-K9 Configuration Manual

Working with Syslogs

Working with Syslogs

Disabling SSL Versions

Cisco 11000 Series Secure Content Accelerator Configuration Guide
4-28
The syslog command gives you greater control over message sent to syslog
servers. The syslog command uses the following syntax:
syslog <ipaddr> [port <portid>] [facility <facilvalue>]
ipaddr
port
portid
facility
facilvalue
Initiate a management session as described previously.
1.
Enter Privileged and Configuration modes.
2.
SCA> enable
SCA# configure
Enter syslog information. Return to Privileged mode.
3.
(config[myDevice])# syslog ip 10.1.1.2.122 port 514 facility 1
(config[myDevice])# end
SCA#
Save the configuration to flash memory. If not saved, the configuration is lost
4.
during a power cycle or when the reload command is used.
SCA# write flash
SCA#
In certain situations, you may want to disable individual SSL versions. The SCA
allows you to enable or disable these on a version-by-version basis for individual
servers.
1. Initiate a management session as described previously.
Chapter 4
The IP address of the syslog server
Keyword identifying the TCP port to be used for
syslog message transfer
A port identification for syslog traffic.
Keyword identifying the facility to be used
The facility number, from 0 to 7.
Using the Configuration Manager
78-13124-06