Probe-Max - Cisco CSS11501S-C-K9 Configuration Manual

Appendix C Command Summary
Usage Guidelines
Related Commands

probe-max

Syntax Description
Usage Guidelines
78-13124-06
off
default
Availability: Serial, Telnet; FIPS Mode (serial only)
The default value of 0 (nopush disabled) allows TCP to send data even if the
segment size is not full. By setting it to 1, nopush is enabled, forcing TCP to wait
until the application sends enough data to fill the segment size. A value of 1 is
useful in applications that are known to consistently send large amounts of data,
such as file transfers. Use the no form of the command to return the nopush to the
global value. If no global settings exist for a parameter, the factory default
parameter is used instead. See RFC 1644.
push-all (TCP Tuning Configuration Command Set)
Specifies the maximum window probe timeout.
probe-max <milliseconds|default>
no probe-max
milliseconds
default
Availability: Serial, Telnet; FIPS Mode (serial only)
Cisco 11000 Series Secure Content Accelerator Configuration Guide
nopush is disabled.
0 (off); nopush is disabled
The maximum window probe timeout; the valid range
is from 30000 to 65535 milliseconds (inclusive).
The factory default. At the time of publication, the
factory default is 60000 milliseconds.
Configuration Command Set
C-197