Cisco CSS11501S-C-K9 Configuration Manual page 212

Command Listing
Table C-5
Command
snmp access-list, page 96
snmp contact, page 97
snmp default community,
page 97
snmp enable, page 98
snmp location, page 99
snmp trap-host, page 100
snmp trap-type enterprise,
page 101
snmp trap-type generic,
page 102
sntp interval, page 103
sntp server, page 104
ssl, page 104
syslog, page 105
telnet access-list, page 106
telnet enable, page 107
telnet port, page 107
timezone, page 108
Cisco 11000 Series Secure Content Accelerator Configuration Guide
C-18
Configuration Command Description (continued)
Description
Assigns an existing access list to be used with the
SNMP subsystem.
Assigns contact information for the SNMP
subsystem. Use the no form of the command to
remove the contact information.
Assigns a default community for the SNMP
subsystem to use when sending trapping
information.
Enables SNMP using the current SNMP
configuration.
Assigns location information for the SNMP
subsystem.
Assigns a destination for SNMP trap messages.
Enables device event trap messages to be sent for a
specific trap-type event and event filter.
Enables generic SNMP traps.
Sets polling interval for all configured SNTP
servers.
Assigns an SNTP server.
Enters SSL Configuration mode for the current
device.
Adds the specified IP address to the syslog list for
the device.
Assigns an existing access list to be used with telnet
management requests.
Allows telnet management sessions for the device.
Specifies the TCP service port to use for telnet
management sessions.
Specifies the time zone of the device's location.
Appendix C Command Summary
78-13124-06