Access Lists; Factory Default Reset Password; Methods To Manage The Device - Cisco CSS11501S-C-K9 Configuration Manual

Appendix C Command Summary

Access Lists

Note

Factory Default Reset Password

Caution

Methods to Manage the Device

78-13124-06
Access lists control which computers can attach to a specific device. No access
lists exist when you first install the Secure Content Accelerator. You can restrict
the computers allowed to manage the appliance by adding their IP addresses to
one or more access lists for each device. For more information about configuring
access lists, see the commands show access-list, access-list, snmp access-list,
telnet access-list, and web-mgmt access-list in Appendix C.
In FIPS Mode you can configure access lists but can assign them
only the SNMP subsystem.
If you have forgotten your access or enable password, you can use a factory-set
password during a serial configuration session. When prompted for a password,
enter FailSafe (case-sensitive). You are asked to confirm the action. The appliance
reboots (reloads) with factory default settings.
All configuration is lost when using the factory default reset
password.
You can configure the Cisco Secure Content Accelerator using one of three
methods, two of which use the CLI configuration manager.
Serial connection, configuration manager
•
An IP address need not have been assigned for appliance management.
–
– A device can be set to single-port mode via serial connection.
– A device must be managed while physically connected via a serial cable.
The FailSafe password can be used as a factory reset.
–
The only management method available in FIPS Mode.
–
Cisco 11000 Series Secure Content Accelerator Configuration Guide
Methods to Manage the Device
C-7