Cisco Secure Content Accelerator Management - Cisco CSS11501S-C-K9 Configuration Manual

Cisco Secure Content Accelerator Management

Cisco Secure Content Accelerator Management
Cisco 11000 Series Secure Content Accelerator Configuration Guide
F-12
You can configure the Cisco Secure Content Accelerator using one of three
methods, two of which use the CLI configuration manager.
• Serial connection, configuration manager
An IP address need not have been assigned for appliance management.
–
A device can be set to single-port mode via serial connection.
–
– A device must be managed while physically connected via a serial cable.
The FailSafe password can be used as a factory reset.
–
Telnet connection, configuration manager
•
– An IP address must have been assigned to the appliance.
A device cannot be set to single-port mode via telnet.
–
Web browser-based GUI
•
– In IP address must have been assigned to the appliance for management.
A device cannot be set to single-port mode via the GUI.
–
Only one device can be managed at a single time.
–
Serial and telnet management commands can use symbolic hostnames in URL
identifiers if the ip domain-name has been set.
File name formats differ depending on the management method. When using the
GUI, you can specify the file name as it appears in the configuring computer's file
system. A path must be included, if necessary. When using serial or telnet
management, the file name must be entered in any of the following formats:
[<http:// | ftp:// | https:// | tftp:// >] URL
In situations where a file is written, anonymous write access must be configured
on the system with these caveats:
http:—The server must be configured to accept PUT commands
•
• https:—The server must be configured to accept PUT commands
ftp:—If anonymous write access is not allowed, use this format:
•
ftp://username:password@host/directory/filename
Appendix F SSL Introduction
78-13124-06