Table D-2 Firmware Image Selection - Cisco CSS11501S-C-K9 Configuration Manual

Appendix D MiniMax Command Summary
Table D-2
Firmware Image File Name
css-sca-2fe-k9.phz
css-sca2-2fe-k9.phz
css-sca-2fe-k9-4_1-to-3_2.phz
css-sca-2fe-k9-3_2-to-4_1.phz
1.
2.
Note
3.
Note
78-13124-06
Firmware Image Selection
Launch any terminal emulation application that communicates with the serial
port connected to the SSL device and supports the Xmodem protocol. Use
these settings: 9600 baud, 8 data bits, no parity, 1 stop bit, no flow control.
3. Enter the do command at the MiniMax prompt. The following is displayed.
>>do
>>
Downloading
SSSS
The "S" is actually a non-ASCII character sent to the screen
while MiniMax is waiting for the file to be sent.
Use the terminal emulation application's commands to initiate sending the
image file indicated in Table D-2 above via xmodem.
The image file transfer can take up to an hour depending on
the baud.
Cisco 11000 Series Secure Content Accelerator Configuration Guide
Purpose
Reflash an SCA with version 4.1
Reflash an SCA2 with version 4.1
Flash a 4.1 SCA with version 3.2
Flash a 3.2 SCA with version 4.1
Examples
D-7