Trap Port Link - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

trap port link

Enables trap link messages. If enabled, a message is displayed on the Network Management Station
(NMS) whenever the specified port changes state.
trap {slot | slot/port[-port2]} port link {enable | disable | on | off}
Syntax Definitions
slot
slot/port[-port2]
enable
disable
on
off
Defaults
parameter
enable | disable | on | off
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Enter a slot number to enable or disable trap link messages for all interfaces on a specific slot.
•
Enter a slot and port number or a range of port numbers to enable or disable trap link messages on a
specific interface or range of interfaces.
Examples
-> trap 3/1 port link enable
-> trap 3 port link enable
-> trap 3/1-6 port link enable
Release History
Release 6.1; command was introduced.
page 1-4
The slot number for a specific module.
The slot and port number (3/1). Use a hyphen to specify a range of ports
(3/1-3/10).
Port link up/down traps are displayed on the NMS.
Port link up/down traps are not displayed on the NMS.
Same as enable.
Same as disable.
default
disable
Ethernet Port Commands
OmniSwitch CLI Reference Guide June 2012