Interfaces Hybrid Crossover - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Ethernet Port Commands

interfaces hybrid crossover

Configures port crossover settings on a single port, a range of ports, or an entire Network Interface (NI).
interfaces {slot | slot/port[-port2]} hybrid copper crossover {auto | mdix | mdi}
Syntax Definitions
slot
slot/port[-port2]
copper
auto
mdix
mdi
Defaults
By default, the interface is configured to automatically detect crossover settings.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855
Usage Guidelines
•
Refer to the Hardware Users Guide for combo port numbering.
•
You cannot configure crossover settings on fiber ports. These ports use the MDI standard.
•
The MIB table and MIB object listed in the "MIB Objects" section below apply to the inactive config-
ured media only. See the "MIB Objects" section in the
and MIB object for the active configured media.
•
Enter a slot number to configure the crossover settings for all interfaces on a specific slot.
•
Enter a slot and port number or a range of ports to configure the crossover settings for a specific inter-
face or a range of interfaces.
Examples
-> interfaces 1/47 hybrid copper crossover disable
-> interfaces 1/47-48 hybrid copper crossover mdix
-> interfaces hybrid copper crossover auto
OmniSwitch CLI Reference Guide
The slot number for a specific module.
The slot and port number (3/1). Use a hyphen to specify a range of ports
(3/1-3/10).
Specifies that changes will be made to the copper 10/100/1000 RJ-45
port(s).
The interface will automatically detect crossover settings.
Sets the crossover configuration to Media Dependent Interface with
Crossover (MDIX), which is the standard for hubs and switches.
Sets the crossover configuration to Media Dependent Interface (MDI),
which is the standard for end stations.
June 2012
interfaces crossover section for the MIB table
page 1-59