Interfaces Violation-Recovery-Trap - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Ethernet Port Commands

interfaces violation-recovery-trap

Enables or disables the sending of a violation recovery trap when any port is re-enabled after the violation
recovery time has expired.
interface violation-recovery-trap {enable | disable}
Syntax Definitions
enable
disable
Defaults
By default, the sending of a violation recovery trap is disabled.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
This is a global command that is applied to all ports on all modules.
Examples
-> interfaces violation-recovery-trap enable
-> interfaces violation-recovery-trap disable
Release History
Release 6.4.3; command was introduced.
Related Commands
interfaces violation-recovery-
time
show interfaces violation-
recovery
MIB Objects
esmViolationRecovery
esmViolationRecoveryTrap
OmniSwitch CLI Reference Guide
Enables the ports to send violation recovery traps.
Disables the ports from sending violation recovery traps.
Configures the time interval to automatically re-enable the ports
that were shutdown due to a violation.
Displays the globally configured recovery time, SNMP recovery
trap status, and maximum recovery attempts.
June 2012 page 1-41