Interfaces Violation-Recovery-Time - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Ethernet Port Commands

interfaces violation-recovery-time

Configures the time interval after which the port is automatically re-activated if the port was shutdown for
any violation. This value is configurable on a global basis (applies to all ports on all modules) and on a
per-slot or per-port basis.
interfaces [slot | slot/port[-port2]] violation-recovery-time {seconds | default}
interfaces {slot | slot/port[-port2]} violation-recovery-time default
Syntax Definitions
slot
slot/port[-port2]
seconds
default
Defaults
•
By default, this command configures the global recovery time. The global value applies to all ports on
all modules in the switch.
•
By default, the violation recovery time is set to 300 seconds.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
When the recovery timer expires, the interface is operationally re-enabled and the violation on the
interface is cleared.
•
The violation recovery time value does not apply to interfaces that are in a permanent shutdown state.
A port in this state is only recoverable using the interfaces clear-violation-all command.
•
The interface violation recovery mechanism is not supported on link aggregates, but is supported on
the link aggregate member ports.
•
Set the recovery time to 0 to disable this violation recovery mechanism.
•
Enter a slot number to configure the recovery time for all interfaces on a specific slot.
•
Enter a slot and port number or a range of ports to configure the recovery time for a specific interface
or a range of interfaces.
•
When this command is used to configure the recovery time for all ports on a slot or for a specific port
or range of ports, the value specified overrides the global maximum recovery time configured for the
switch.
OmniSwitch CLI Reference Guide
The slot number for a specific module.
The slot and port number (3/1). Use a hyphen to specify a range of ports
(3/1-3/10).
The number of seconds after which a port is reactivated. The valid range
is 30-600 seconds or specify 0 to disable the recovery timer.
Sets the recovery time to the global value for the specified ports. This
parameter is only available when a slot, port, or range of ports is speci-
fied with this command.
June 2012 page 1-37