Interfaces Transceiver Ddm - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Ethernet Port Commands

interfaces transceiver ddm

Configures the DDM administrative status or trap capability.
interfaces transceiver ddm [trap] {enable | disable}
Syntax Definitions
trap
enable
disable
Defaults
parameter
ddm
trap
By default, the polling period is set to 60 seconds for the OS6850 and 1 second for the OS6400/6855.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
DDM capability will vary based on the transceiver manufacturer.
•
DDM status must be enabled in order to enable traps; traps are enabled separately.
•
Information will be read sequentially from a different SFP at the predefined Polling intervals listed in
the defaults table above. The number of SFPs in the switch will determine how often each SFP is
polled.
Examples
-> interfaces transceiver ddm enable
-> interfaces transceiver ddm trap enable
-> interfaces transceiver ddm trap disable
-> interfaces transceiver ddm disable
Release History
Release 6.4.2; command was introduced.
OmniSwitch CLI Reference Guide
Indicates the enable / disable parameter applies to the traps
functionality.
Enables DDM functionality or traps warning/alarm threshold violations.
Disables DDM functionality or traps warning/alarm threshold viola-
tions.
default
disable
disable
June 2012 page 1-45