Modifying The Dynamic Aggregate Group Actor System Priority - Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual

Configuring Dynamic Link Aggregation
Configuring and Deleting the Dynamic Aggregate Group Actor
Administrative Key
The following subsections describe how to configure and delete a dynamic aggregate group actor
administrative key with the
Configuring a Dynamic Aggregate Actor Administrative Key
To configure the dynamic aggregate group actor switch administrative key, enter linkagg lacp agg
followed by the dynamic aggregate group number, actor admin-key, and the value for the administrative
key.
For example, to configure dynamic aggregate group 4 with an administrative key of 10, enter:
-> linkagg lacp agg 4 actor admin-key 10
Deleting a Dynamic Aggregate Actor Administrative Key
To remove an actor switch administrative key from the configuration of a dynamic aggregate group, use
the no form of the linkagg lacp agg actor admin-key
by the dynamic aggregate group number and the actor admin-key parameter.
For example, to remove an administrative key from dynamic aggregate group 4, enter:
-> no linkagg lacp agg 4 actor admin-key

Modifying the Dynamic Aggregate Group Actor System Priority

By default, the dynamic aggregate group actor system priority is 0. The following subsections describe
how to configure a user-specified value and how to restore the value to its default value with the
lacp agg actor system-priority
Configuring a Dynamic Aggregate Group Actor System Priority
You can configure a user-specified dynamic aggregate group actor system priority value by entering
linkagg lacp agg followed by the dynamic aggregate group number, actor system-priority, and the new
priority value.
For example, to change the actor system priority of dynamic aggregate group 4 to 2000, enter:
-> linkagg lacp agg 4 actor system-priority 2000
Restoring the Dynamic Aggregate Group Actor System Priority
To restore the dynamic aggregate group actor system priority to its default (0) value use the no form of the
linkagg lacp agg actor system-priority
dynamic aggregate group number and no actor system priority.
For example, to restore the actor system priority to its default value on dynamic aggregate group 4, enter:
-> no linkagg lacp agg 4 actor system-priority
OmniSwitch AOS Release 8 Network Configuration Guide
linkagg lacp agg actor admin-key
command.
command by entering no linkagg lacp agg followed by the
Modifying Dynamic Link Aggregate Group Parameters
command.
command by entering linkagg lacp agg followed
December 2017
linkagg
page 9-13