Ocp Module Replacement - Lenovo ThinkEdge SE455 V3 User Manual

Step 4. Install the memory module into the slot.
a. Make sure the retaining clips are in the fully-open position.
b. Align the memory module with the slot, and gently place the memory module on the slot
with both hands.
c. Firmly press both ends of the memory module straight down into the slot until the retaining
clips snap into the locked position.
Attention:
• To avoid breaking the retaining clips or damaging the memory module slots, open and close the
clips gently.
• If there is a gap between the memory module and the retaining clips, the memory module has
not been correctly inserted. In this case, open the retaining clips, remove the memory module,
and then reinsert it.
Figure 108. Installing a memory module
After this task is completed
Complete the parts replacement. See

OCP module replacement

Follow instructions in this section to remove and install the OCP module.
Remove the OCP module
Follow the instructions in this section to remove the OCP module.
About this task
Attention:
• Read "Installation Guidelines" on page 39
work safely.
• If applicable, remove the security bezel. See
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
138 ThinkEdge SE455 V3 User Guide
"Complete the parts replacement" on page
and "Safety inspection checklist" on page 40
"Remove the security bezel" on page
48.
225.
to ensure that you
195.