Step 2.
Fasten the screw to secure the front panel to the chassis.
Figure 72. Securing front panel to the chassis
Step 3.
Connect the power button cable to the system board, see
Procedure
1. Reinstall the front bezel, see
2. Proceed to complete the parts replacement, see
Heat sink and fan module replacement
Follow this procedure to remove and install the heat sink and fan module.
Remove the heat sink and fan module (trained technician only)
Follow this procedure to remove the heat sink and fan module. This procedure must be executed by a trained
technician.
"Install the front bezel" on page
"Complete the parts replacement" on page
"Internal cable routing" on page
86.
.
Chapter 3
Hardware replacement procedures
19.
158.
93