Table of Contents
Advertisement
• If the server is installed in a rack, remove the server from the rack. See
on page
49.
Procedure
Step 1.
Remove the OCP module.
a.
Loosen the thumbscrew that secures the OCP module. Use a screwdriver if necessary.
b.
Grasp the handle, and slide the OCP module out.
Figure 109. Removing the OCP module
After this task is completed
1. Install a replacement unit or an OCP filler into the empty slot. See
Figure 110. Installing the OCP filler
To install an OCP filler, insert one side of the filler into the slot; then, pivot the other side into the slot until
the filler is firmly seated.
"Remove the server from the rack"
"Install the OCP module" on page
.
Chapter 5
Hardware replacement procedures
140.
139
Advertisement
Table of Contents
Troubleshooting
