Lenovo ThinkEdge SE455 V3 User Manual page 114

About this task
Attention:
• Read "Installation Guidelines" on page 39
work safely.
• If applicable, remove the security bezel. See
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• If the server is installed in a rack, remove the server from the rack. See
on page 49.
• If one or more NVMe solid-state drives are to be removed, it is recommended to disable them beforehand
via the operating system.
• Before you remove or make changes to drives, drive controllers (including controllers that are integrated
on the system board), drive backplanes or drive cables, back up all important data that is stored on drives.
• Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration
information.
Procedure
Step 1. Make preparation for this task.
a. Remove the top cover. See
Step 2. Pinch and lift the handles to pivot the internal drive cage up.
Figure 75. Pivoting the internal drive cage
Step 3. Locate the internal drive to be removed.
Table 20. Internal drive bay numbering (viewed from the front of the internal drive cage)
Bay 4
Bay 5
Step 4. Remove the internal drive.
a. Slide the release latch to unlock the drive handle.
106 ThinkEdge SE455 V3 User Guide
and "Safety inspection checklist" on page 40
"Remove the security bezel" on page
48.
"Remove the top cover" on page
"Remove the server from the rack"
223.
Bay 6
Bay 7
to ensure that you
195.