Lenovo ThinkEdge SE455 V3 User Manual page 112

• Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration
information.
The following notes describe the type of drives that the server supports and other information that you must
consider when you install a drive. For a list of supported drives, see
• Locate the documentation that comes with the drive and follow those instructions in addition to the
instructions in this chapter.
• The drive bays are numbered to indicate the installation order (starting from number "0"). Follow the
installation order when you install a drive.
Table 19. Front drive bay numbering (viewed from the front)
Bay 0
Bay 1
Firmware and driver download: You might need to update the firmware or driver after replacing a
component.
• Go to
https://datacentersupport.lenovo.com/products/servers/thinkedge/se455v3/7dby/downloads/driver-list/
to see the latest firmware and driver updates for your server.
• Go to "Update the firmware" on page 260
Procedure
Step 1. If a drive filler is installed in the drive bay, remove it first. Keep the drive filler in a safe place for
future use.
Figure 73. Removing a drive filler
Step 2. Install the drive.
a. Slide the drive into the drive bay, and push it until it stops.
b. Rotate the handle back to the locked position.
104 ThinkEdge SE455 V3 User Guide
https://serverproven.lenovo.com
Bay 2
Bay 3
for more information on firmware updating tools.
.