Table of Contents
Advertisement
Note: Depending on the configuration, the drive backplane might look slightly different from the illustration in
this section.
Procedure
Step 1.
Make preparation for this task.
a.
Remove the top cover. See
b.
Remove all the internal drives. See
Step 2.
Pinch the blue touch points on the backplane bracket as shown; then, lift the backplane to remove
it.
Figure 77. Removing the internal drive backplane
Step 3.
Disconnect the cables from the drive backplane.
Step 4.
If necessary, loosen the two screws to separate the drive backplane from the backplane bracket.
108
ThinkEdge SE455 V3 User Guide
"Remove the top cover" on page
"Remove an internal drive" on page
223.
105.
Advertisement
Table of Contents
Troubleshooting
