Chapter 6. Internal Cable Routing; Identifying Connectors; Drive Backplane Connectors - Lenovo ThinkEdge SE455 V3 User Manual

Chapter 6. Internal cable routing

See this section to do cable routing for specific components.
Note: Disengage all latches, release tabs, or locks on cable connectors when you disconnect cables from
the system board. Failing to release them before removing the cables will damage the cable sockets on the
system board, which are fragile. Any damage to the cable sockets might require replacing the system board.

Identifying connectors

See this section to locate and identify the connectors on the electric boards.

Drive backplane connectors

See this section to locate the connectors on the drive backplanes.
Two types of drive backplanes are supported in this server:
SAS/SATA backplane
See this section to locate the connectors on the SAS/SATA drive backplane.
Power connector
1
SAS/SATA connector
2
Figure 199. SAS/SATA backplane connectors
NVMe backplane
See this section to locate the connectors on the NVMe drive backplane.
NVMe 2-3
1
NVMe 0-1
2
Power connector
3
Figure 200. NVMe backplane
© Copyright Lenovo 2023 227