Lenovo ThinkEdge SE455 V3 User Manual page 61

Rail kit
ThinkEdge 600mm Ball Bearing Rail Kit
or
ThinkEdge 2-Post Friction Rail Kit
ThinkEdge 1000mm Friction Rail Kit v2
Figure 19. One screw for the inner rail of ThinkEdge 600mm Ball Bearing Rail Kit
Figure 20. One screw for the inner rail of ThinkEdge 2-Post Friction Rail Kit
Figure 21. Two screws for the inner rail of ThinkEdge 1000mm Friction Rail Kit v2
Figure 22. Three screws for the inner rail of ThinkEdge 1000mm Friction Rail Kit v2
b. Slightly push the inner rail to the right to disengage the inner rail from the mounting pins on
the server.
c. Remove the inner rail from the server.
d. Repeat this procedure to remove the other inner rail.
Step 4. If necessary, remove the rail kit from the rack. See the Rail Installation Guide which comes with the
rail kit, or download the Rail Installation Guide from
Remove the EIA brackets
Follow instructions in this section to remove the EIA brackets.
About this task
Attention:
Depth of EIA brackets
Any
#1, #2, #3, #4
#5, #6, Max
"Documents download" on page
.
Chapter 5 Hardware replacement procedures
The number of screws
for each inner rail
1
2
3
309.
53