Refresh Settings - Mitsubishi Electric MELSEC iQ-F FX5 Series User Manual

Refresh settings

Assign link refresh ranges between the following devices.
• SB, SW, link devices (RX, RY, RWr, RWw) of the Motion module  Devices of the CPU module
Setting method
The procedure for the refresh settings is as follows.
1.
Set the required items.
2.
Click the [Apply] button to finish "Refresh Settings".
Setting items
The setting items for the refresh settings are as follows.
Item Description
Device Assignment Right-click in the setting window and select a link device assignment method
Method from the "Device Assignment Method" menu.
• Start/End: Enter the start and end numbers of link devices.
• Points/Start: Enter the numbers of points and start numbers of link devices.
Link Side Set the link refresh ranges of SB and SW. One link refresh range can be set for

each of SB and SW. ( Page 27 Link refresh)
Ex.
00000H
·
001FFH
00000H
·
CPU Side
001FFH
Device name
(SB)
Device name
(SW)
Motion module
Setting range
• Start/End
• Points/Start
(Default: Start/End)
■Device Name
• SB (fixed)
• SW (fixed)
■Points
• SB: 16 to 4096 (set in increments of 16 points)
• SW: 1 to 4096
(Default: empty)
■Start
• SB: 0H to FF0H (set in increments of 16 points)
• SW: 0H to FFFH (set in increments of 1 point)
(Default: empty)
00000H
Device name
· ■End
(SB)
• SB: FH to FFFH (set in increments of 16 points)
001FFH
• SW: 0H to FFFH (set in increments of 1 point)
00000H
(Default: empty)
Device name
·
(SW)
■Target
001FFH
• Specify Device
(Default: empty)
■Device name
• Specify Device (link side is SB): SB, M, L, B, D,
R
• Specify Device (link side is SW): SW, M, L, B, D,
R
CPU module
(Default: empty)
■Points, End
Displayed according to setting of "Start".
(Default: empty)
■Start
Device range of CPU modules (Set bit devices in
increments of 16 points and word devices in
increments of 4 points.)
(Default: empty)
5 PARAMETER SETTINGS
5.3 Basic Settings
5
101