Mitsubishi Electric MELSEC iQ-F FX5 Series User Manual page 90

Connection of servo amplifiers, remote I/O modules, and inverters (for star topology)
The following figure shows connection of Motion module + servo amplifiers + remote I/O modules + inverters (for star
topology).
No.0
Class B (1 Gbps)
No.0: Motion module (master station)
No.1, No.2: Servo amplifiers (remote station)
No.3, No.5: Inverter (remote station)
No.4: Remote I/O module (remote station)
• Device stations can be connected up to the maximum number of connectable stations specified in the CC-
Link IE TSN performance specifications.
• A system in which line topology and star topology coexist using a TSN switching hub can be configured.
(For the available TSN switching hubs, refer to the CC-Link Partner Association website (www.cc-link.org).)
• To use a TSN switching hub, settings of IP address and communication cycle for communicating on CC-
Link IE TSN are required.
• General-purpose switching hubs cannot be used. (By using a general-purpose switching hub, an error
related to device station disconnection or time synchronization may occur.)
4 SYSTEM CONFIGURATION
88
4.5 Connection Examples
No.1
TSN switching hub
Class B (1 Gbps)
General-purpose
switching hub
No.3
Class B (1 Gbps)
No.2 No.4
Class B (1 Gbps) Class B (1 Gbps)
No.5
Class B (1 Gbps)