Refresh Settings - Mitsubishi Electric MELSEC iQ-R Series User Manual

Refresh Settings

Assign link refresh ranges between the devices described below.
• SB, SW, link devices (RX, RY, RWr, RWw, LB, LW) of the Motion module  Devices of the CPU module
Setting method
The procedure for the refresh settings is shown below.
1.
Set the required items.
2.
Click the [Apply] button to finish the refresh settings.
Setting items
Item Description
Device Assignment Right-click the setting screen and select a link device assignment
Method method in "Device Assignment Method".
Link Side Set the link refresh ranges of the link special relay (SB) and link

special register (SW). One range can be set for each SB and SW.
(Page 100 Refresh Settings)
CPU Side
2 PARAMETER SETTINGS
100
2.3 Basic Settings
• Start/End: Enter the start and end numbers of link devices.
• Points/Start: Enter the numbers of points and start numbers of link
devices.
Ex.
00000H
·
SB
007FFH
00000H
·
SW
001FFH
Motion module
Setting range
• Start/End
• Points/Start
(Default: Start/End)
■Device Name
• SB (fixed)
• SW (fixed)
■Points
• SB: 16 to 4096
• SW: 1 to 4096
(Default: Grayout)
■Start
00000H
• SB: 0H to FF0H (set in increments of 16 points)
·
SB
• SW: 0H to FFFH (set in increments of 1 point)
007FFH
(Default: empty)
00000H
■End
·
SW
• SB: FH to FFFH (set in increments of 16 points)
001FFH
• SW: 0H to FFFH (set in increments of 1 point)
(Default: empty)
■Target
• Specify Device
(Default: empty)
■Device Name
• Specify Device (link side is SB): SB, M, L, B, D, R, ZR, RD
• Specify Device (link side is SW): SW, M, L, B, D, R, ZR, RD
CPU module
(Default: Grayout)
■Points, End
• For a specified device: Displayed corresponding to the
setting of "Start".
(Default: Grayout)
■Start
• For a specified device: Device range of CPU modules (Set
bit devices in increments of 16 points and word devices in
increments of 4 points.)
(Default: Grayout)