Keypad (Command Center) Assignment - Bosch D9412GV4 Program Entry Manual

D9412GV4/D7412GV4/D7212GV4
Command Center
Default:
Selection:
SDI Address
(CC#)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Enter the keypad (CC) number for the SDI address you are programming. This number
corresponds to the DIP switch address settings shown.
Switch 5: On=Encoding Tone On (default), Off=Encoding Tone Off
3.11.1

Keypad (Command Center) Assignment

This programming category assigns a keypad to an area and determines if the keypad is
supervised. The keypads are connected to the control panel using a two-wire serial data
interface (SDI) bus.
This bus can support up to sixteen supervised keypads, each with its own unique keypad
address (CC) and corresponding DIP switch address settings. If the keypads are not
supervised, you can install multiple keypads with the same DIP switch address setting for up
to 32 unsupervised keypads.
Enhanced keypads (D1260 Series) and standard keypads (D1255 Series) cannot share the
same SDI Address.
NOTICE!
The D1255 can be addressed as 1 through 16. The D1260 can be addressed only as 1 – 8.
CC# Supervised
Default:
Selection:
Yes
No
Supervise this SDI address and generate Trouble SDI Reports and local trouble annunciation if
a problem occurs with this keypad or the SDI bus.
Bosch Security Systems, Inc.
1
1 to 16 for D9412GV4 and D7412GV4
1 to 8 for D7212GV4
DIP Switch Setting
1 2
ON ON
OFF ON
ON OFF
OFF OFF
ON ON
OFF ON
ON OFF
OFF OFF
ON ON
OFF ON
ON OFF
OFF OFF
ON ON
OFF ON
ON OFF
OFF OFF
No
Yes or No
Only one keypad can be installed for this CC SDI address.
More than one keypad can be installed using this CC SDI address with
the same address DIP switch setting.
Program Entry Guide
Panel and Area Wide Parameters | en
3 4
ON ON
ON ON
ON ON
ON ON
OFF ON
OFF ON
OFF ON
OFF ON
ON OFF
ON OFF
ON OFF
ON OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
F.01U.218.312 | 04 | 2012.03
79
5 6
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON