Bosch D9412GV4 Program Entry Manual page 43

D9412GV4/D7412GV4/D7212GV4
8.
9.
10. The [PREV] button acts as a [Backspace] key. Press [PREV] to delete the characters of
11. Press [ENT] to save the changes.
When the keypad reads PARAMETER SAVED, your selection is configured.
12. Press [NEXT]. The currently configured path poll rate shows.
13. Press [ENT] to change the path poll rate.
14. The [PREV] button acts as a [Backspace] key. Press [PREV] to delete the characters of
15. Press [ENT] to save the changes.
When the keypad reads PARAMETER SAVED, your selection is configured.
D1260
1.
2.
3.
4.
5.
NOTICE!
The keypad only accepts byte numbers valid for the current prompt.
6.
When the keypad reads Parameter Saved, your selection is configured.
7.
8.
9.
10. Press the Save softkey to save the changes.
When the keypad reads Parameter Saved, your selection is configured.
11. When the keypad shows the currently configured port number and the Poll Rate option,
12. Press the Edit softkey to change the path poll rate.
13. The Backspace softkey allows you to erase characters. The Clear softkey allows you to
14. Press the Save softkey to save the changes. When the keypad reads Parameter Saved,
Bosch Security Systems, Inc.
The keypad shows the currently configured network address. Press [NEXT]. The currently
configured port number shows.
Press [ENT] to change the port number.
the port number and then enter the new port number.
the poll rate then enter the new poll rate.
Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access Keypad Programming
and navigate to the Enhanced Comm option. Press [ENT].
The Enhanced Enabled configuration shows, as does the Select IP Path option. Press the
Select IP Path to access the Path (1 – 4) prompt.
Enter the path number you wish to configure and press [ENTER]. The currently
configured network address shows.
Press the Select IP Path softkey to change the IP address. An editing cursor is enabled
for the first byte.
The Previous and Next softkeys move the cursor through the bytes. The Backspace
softkey allows you to erase characters. The Clear softkey allows you to clear the entire IP
address. Use the softkeys and the number buttons on the keypad to enter the new
network address.
Press the Save softkey to save the changes.
The keypad shows the currently configured network address and the Port Number
option. Press the Port Number softkey. The currently configured port number shows.
Press the Edit softkey to change the port number.
The Backspace softkey allows you to erase characters. The Clear softkey allows you to
clear the entire network address. Use the softkeys and the number buttons on the
keypad to enter the new port number.
press the Poll Rate softkey. The currently configured path poll rate shows.
clear the entire poll rate. Use the softkeys and the number buttons on the keypad to
enter the new poll rate.
your selection is configured.
Program Entry Guide
Panel and Area Wide Parameters | en
F.01U.218.312 | 04 | 2012.03
43