Bosch D9412GV4 Program Entry Manual page 183

D9412GV4/D7412GV4/D7212GV4
5.
6.
NOTICE!
The keypad does not accept invalid byte numbers.
7.
IPv4 DNS Server IP Address
Default:
Selection:
This This defines the address of the Doman Name Server (DNS). When this is defined through
the DHCP service, leave the default value.
Keypad Programming of IPv4 DNS Server IP Address
D1255
1.
2.
3.
4.
5.
NOTICE!
The keypad does not accept numbers 256 to 999.
6.
7.
D1260
1.
2.
3.
4.
5.
6.
Bosch Security Systems, Inc.
To change the setting, press the Edit softkey.
The Previous and Next softkeys move the cursor through the bytes. The Backspace
softkey allows you to erase characters. The Clear softkey allows you to clear the entire
address. Use the softkeys and the number buttons on the keypad to enter the new
address.
Press the Save softkey to save the changes.
0.0.0.0
0.0.0.0 to 255.255.255.255
Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access the TOOLS MENU
and navigate to the PROGRAMMING option.
Press [ENT] to enter the PROGRAMMING option.
Press [ENT] at the DNS PARAM option to enter it.
Press [ENT] at the SERVER ADDRESS option. The currently configured server address
shows. An invisible editing cursor is enabled for the first byte.
The [PREV] button acts as a [Backspace] key. Press [PREV] to delete the characters of
the byte, and then enter the new byte numbers, or press [NEXT] to move to the next
byte.
Repeat Step 5 to enter the correct numbers for each byte.
Press [ENT] to save the changes.
Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access the Tools Menu and
navigate to the Programming option.
Press [ENTER] to enter the Programming option.
Press [ENTER] at the DNS Parameters option to enter it.
Press [ENTER] at the Server Address option. The current configured default gateway
shows.
To change the setting, press the Edit softkey.
The Previous and Next softkeys move the cursor through the bytes. The Backspace
softkey allows you to erase characters. The Clear softkey allows you to clear the entire
address. Use the softkeys and the number buttons on the keypad to enter the new
address.
Program Entry Guide
SDI2 Modules | en 183
F.01U.218.312 | 04 | 2012.03