Bosch D9412GV4 Program Entry Manual page 38

38 en | Panel and Area Wide Parameters
NOTICE!
When activating an on-board relay using remote automation software, the GV4 Series Control
Panels log and print the resulting event as:
Relay 250 (Relay A)
Relay 251 (Relay B)
Relay 252 (Relay C)
Auto Function Reports
The following prompts support customized routing of Auto Function Reports. Selecting Yes
enables a report to be sent when the event occurs.
Report
R# Sked Executed
R# Sked Changed
R# Execute Fail
RPS Reports
Selecting Yes enables sending a report when the RPS Passcode Event occurs.
NOTICE!
"RPS Access Fail" might indicate a wrong RPS passcode when communicating with the control
panel, or a valid RPS session was abnormally terminated. "Remote Reset" indicates a Reset
command was issued from RPS. "Fail to Call RPS" indicates that control panel called RPS, but
was unable to connect.
Report
R# Log Threshold
R# Service End
R# Parameters Changed
R# RPS Access OK
R# RPS Access Fail
R# Remote Reset
R# Program Access OK
R# Program Access Fail
Table 3.11 RPS Reports
Point Reports
Selecting Yes enables a report to be sent when the event occurs.
F.01U.218.312 | 04 | 2012.03
Selections Report Description
Yes, No Sked Executed Event
Yes, No Sked Changed Event
Yes, No Fail to Execute Event
Selections Report Description
Yes, No Reports Service Walk Test Start Event
Yes, No Service Walk Test End Event
Yes, No RPS Parameters were changed
Yes, No Successful RPS access
Yes, No RPS failed to access control panel
Yes, No Control panel reset by RPS
Yes, No Successful local programming
Yes, No Local programming failed
Program Entry Guide
D9412GV4/D7412GV4/D7212GV4
Bosch Security Systems, Inc.