Area Relays - Bosch D9412GV4 Program Entry Manual

Table of Contents

Advertisement

118 en | Panel and Area Wide Parameters
Relay functions that resume the proper state within one minute of reboot:
Alarm Bell
Summary Fire
Area Armed
Fire Bell
Summary Alarm
Silent Arm
Summary Fire Trouble
Watch Mode
Relay functions that must be reset manually with Change Relay function (COMMAND 54):
Fail To Close
Duress
3.14.1

Area Relays

Each area can be assigned a unique relay number for each of the events listed in this section.
A# Alarm Bell
Default:
Selection:
This voltage output relay activates and provides 12 VDC output when a Non-fire point (P##
Fire is No) assigned to this area activates an alarm.
NOTICE!
A# Burg Time and A# Burg Pattern must be programmed in Area or Bell Parameters. This relay
activates according to the bell pattern and remains active until the bell time expires or a valid
passcode is entered. P## Silent Bell must be No for the bell to ring upon alarm.
For SIA CP-01 Compliance:
Do not set A# Alarm Bell to 0. This feature is required for SIA CP-01 compliance.
A# Fire Bell
Default:
Selection:
This voltage output relay activates and provides 12 VDC output when a Fire point (P## Fire is
Yes) assigned to this area activates an alarm.
F.01U.218.312 | 04 | 2012.03
Do not use the CHANGE RELAYS? function to toggle relays reserved for special functions.
Special function relays are Area and Panel Wide Relay functions as well as relays assigned
to CC Enter Key Relay and P## Relay Response Type.
Relay C is always on. Assigning any other relay (1 to 128, A or B) deactivates Relay C so
this output can be used for other functions. When Relay C is programmed for A# Rest
Sensors, power is always supplied from Terminal 8 of the control panel.
Relay Restoration: The status of relays after programming or resetting the control panel
might restore automatically or require manual restoration. All relays are turned off after
the control panel reboots. The control panel checks certain relay functions every minute
and resumes the correct state after the reset. Other relays must be manually set to the
correct state using the Change Relay Function (COMMAND 54).
A
0, 1 to 128, A, B, C for D9412GV4
0, 1 to 64, A, B, C for D7412GV4
0, 1 to 24, A, B, or C for D7212GV4
A
0, 1 to 128, A, B, C for D9412GV4
0, 1 to 64, A, B, C for D7412GV4
0, 1 to 24, A, B, or C for D7212GV4
Program Entry Guide
D9412GV4/D7412GV4/D7212GV4
Perimeter Fault
Summary Trouble
Reset Sensors
AC Fail
Phone Fail
Summary SupBurg
Communications Fail
Summary SupFire
Force Armed
Bosch Security Systems, Inc.

Advertisement

Table of Contents
loading

This manual is also suitable for:

D7412gv4D7212gv4

Table of Contents