Bosch D9412GV4 Program Entry Manual page 129

D9412GV4/D7412GV4/D7212GV4
User ### Card Data: Enter the remaining five decimal numbers on the back of the token or
card. This is the second and third byte (bits 10 through 25) of data for a 26-bit Wiegand card.
This is called the card data.
You must program U### Site Code before programming this prompt.
U### Keyfob ID
Default
Selection:
Each user can be assigned a wireless keyfob ID. A Keyfob RFID can be Auto-Learned through
the SDI2 bus RF receiver, or it can be entered here. Auto-Learned RFIDs can be edited for
Keyfob replacement, or can be set to 0 to disable a users Keyfob. A RFID (Radio Frequency
device IDentification number) is a unique number assigned to a wireless device at the factory.
It provides a unique way for the Wireless Receiver and Wireless Repeaters to identify what
device is transmitting.
NOTICE!
Duplicate ID detection must be based on the RFID value stored in configuration memory, not
on the number printed on the device.
NOTICE!
Keyfobs are not supervised when assigned to a User.
Bosch Security Systems, Inc.
Passcodes, Access Credentials, and User Groups | en 129
0
0 - 99999999
Program Entry Guide F.01U.218.312 | 04 | 2012.03