Bosch D9412GV4 Program Entry Manual page 182

182 en | SDI2 Modules
6.
7.
D1260
1.
2.
3.
4.
5.
6.
NOTICE!
The keypad does not accept invalid byte numbers.
7.
IPv4 Default Gateway
Default:
Selection:
This defines the address of the Internet or Intranet gateway. When this is defined through the
DHCP service, leave the default value.
Keypad Programming of IPv4 Default Gateway
D1255
1.
2.
3.
4.
5.
NOTICE!
The keypad does not accept numbers 256 to 999.
6.
7.
D1260
1.
2.
3.
4.
F.01U.218.312 | 04 | 2012.03
Repeat Step 5 to enter the correct numbers for each byte.
Press [ENT] to save the changes.
Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access the Tools Menu and
navigate to the Programming option.
Press [ENTER] to enter the Programming option.
Press [ENTER] at the Address Parameters option to enter it.
Press [ENTER] at the Subnet Mask option. The current configured subnet mask shows.
To change the setting, press the Edit softkey.
The Previous and Next softkeys move the cursor through the bytes. The Backspace
softkey allows you to erase characters. The Clear softkey allows you to clear the entire IP
address. Use the softkeys and the number buttons on the keypad to enter the new IP
address.
Press the Save softkey to save the changes.
0.0.0.0
0.0.0.0 to 255.255.255.255
Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access the TOOLS MENU
and navigate to the PROGRAMMING option.
Press [ENT] to enter the PROGRAMMING option.
Press [ENT] at the ADDRESS PARAM option to enter it.
Press [ENT] at the DEFAULT GATEWAY option. The currently configured default gateway
shows. An invisible editing cursor is enabled for the first byte.
The [PREV] button acts as a [Backspace] key. Press [PREV] to delete the characters of
the byte, and then enter the new byte numbers, or press [NEXT] to move to the next
byte.
Repeat Step 5 to enter the correct numbers for each byte.
Press [ENT] to save the changes.
Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access the Tools Menu and
navigate to the Programming option.
Press [ENTER] to enter the Programming option.
Press [ENTER] at the Address Parameters option to enter it.
Press [ENTER] at the Default Gateway option. The current configured default gateway
shows.
Program Entry Guide
D9412GV4/D7412GV4/D7212GV4
Bosch Security Systems, Inc.