Bosch D9412GV4 Program Entry Manual page 141

D9412GV4/D7412GV4/D7212GV4
NOTICE!
When the point cannot return to the system through disarming, the point must be manually
unbypassed using the Unbypass keypad function, Sked Functions 4 and 5, or remote
programming software (RPS).
NOTICE!
For Force Armed points to remain bypassed, ensure that P## Force Arm Returnable is set to
No.
P## Bypassable
Default:
Selection:
Yes
No
NOTICE!
To meet UL 864 requirements (D9412GV4 and D7412GV4), set this parameter to No.
Bypassing a 24-hour point: When a 24-hour point or 24-hour Supervisory point is bypassed,
24 HOUR BYPASS scrolls continuously at the keypad.
Bypassing a Fire Point: FIRE BYPASS scrolls to indicate that a 24-hour Fire point or a Fire
Supervisory point is bypassed.
NOTICE!
Alternative to a 24-hour Point: For alarm capability of a 24-hour point without the continuous
scrolling, use a Perimeter point with a Point Response of 9 to E.
NOTICE!
If the P## Bypassable option is set to Yes, a point can be bypassed in several ways. Refer to
Table 5.1.
Bypass with:
Keypad using the Bypass? function
Keypad using Command 0
Sked Function 3
Remote programming software (RPS)
*
RPS Bypass is sent at the end of the RPS session
Table 5.1 Bypassing a Point
NOTICE!
If the P## Swinger Bypass option is set to Yes, a point is automatically bypassed after the
fourth alarm or trouble report is sent. A swinger Bypass report is sent at the same time.
Bosch Security Systems, Inc.
Refer to the program record sheet
Yes or No
This point can be bypassed and force armed.
This point cannot be bypassed or force armed from the keypad or
remote programming software (RPS); however, it can be force armed
by automatic arming at the end of the Closing Window (refer to the A#
Auto Close prompt in Section 3.10.4 Open/Close Options, page 69 or by
a Sked programmed to arm the area.
Report sent
Command Bypass
Command Bypass
Sked Bypass
RPS Bypass*
.
Program Entry Guide
Points | en 141
F.01U.218.312 | 04 | 2012.03