Bosch D9412GV4 Program Entry Manual page 123

Hide thumbs Also See for D9412GV4:

Table of Contents

D9412GV4/D7412GV4/D7212GV4

When it reaches 100% capacity (memory logger is full and previously stored events will be

overwritten), the control panel generates a local LOG OVERFLOW event. The control panel

does not call RPS again until it downloads the log and the Log % Full percentage is again

reached. These events are also sent to the control panel's event log and to the local printer(s)

if installed.

Summary Fire

Default:

Selection:

Enter the number of the relay that activates when any Fire point in the system (P## Type 0,

P## Fire Yes) enters into alarm. This relay provides a steady output until all Fire points in the

system return to normal. Refer to Section Fire Summary Sustain, page 175 for details on

alternate operation.

Summary Alarm

Default:

Selection:

Enter the number of the relay that activates when a Non-fire point enters into alarm. This relay

provides a steady output until the alarm is acknowledged by a valid passcode, then cleared

from alarm memory with an acknowledgment at the keypad.

NOTICE!

This relay does not activate for silent and invisible alarms.

Summary Fire Trouble

Default:

Selection:

Activates when any Fire point in the control panel is in trouble, or if a Fire Supervision point is

missing. This relay provides a steady output until all Fire points restore to a normal condition.

Summary Supervisory Fire

Default:

Selection:

Activates when any Fire Supervisory point in the control panel is in a supervisory condition

(off-normal). This relay provides a steady output until all Fire Supervisory points are restored

to a normal condition.

Summary Trouble

Default:

Selection:

Bosch Security Systems, Inc.

0, 1 to 128 A, B, or C for D9412GV4

0, 1 to 64, A, B, C for D7412GV4