Olivetti d-Color MF4003 Service Manual page 196

d-Color MF4003/MF3303
7. Expert Adjustment
NOTE
▪ It will not be displayed when [Service Mode] -> [Billing Setting] -> [Management Function Choice] shows that the "Vendor 2" is
mounted. (It will be displayed when the Key Counter is mounted or [Service Mode] -> [System 2] -> [Software Switch Setting]
shows that switch No.33 is set to [00000001] at Bit assignment/[01] at HEX assignment.)
Key name
AE Level Adjustment -
Printer Adjustment Leading Edge Adjustment
Centering
Leading Edge Adjustment
(Duplex Side 2)
Centering (Duplex 2nd
Side)
Erase Leading Edge
Vertical Adjustment
Media Adjustment
Image Stabilization -
Paper Separation -
Adjustment
Color Registration Adjust This menu is unavailable when the key counter is not inserted while "Key Counter Only" is set by [Service Mode] -
> [Billing Setting] -> [Management Function Choice].
Gradation Adjustment
Scanner Area
ADF Adjustment Centering
Original Stop Position
Centering Auto Adjustment
Auto Adj. of Stop Position
User Paper Settings
Erase Adjustment -
PS Designer Settings -
Main Scanning Direction -
Zoom
Trouble isolation It will be displayed when the finisher is mounted.
Service Manual
This menu is unavailable when the key counter is not inserted while "Key Counter
Only" is set by [Service Mode] -> [Billing Setting] -> [Management Function Choice].
It will be displayed when [Service Mode] -> [Enhanced Security] -> [Administrator
Feature Level] is set to "Level 2."
• The adjusted values from [Erase Leading Edge] are also updated to the service
• The adjusted values from [Vertical Adjustment] are also updated to the service
This function is provided to open
administrator and the fine-adjusted value is reflected in the Service Mode setting.
• This menu is unavailable when the key counter is not inserted while "Key Counter Only" is set by [Service
Mode] -> [Billing Setting] -> [Management Function Choice].
• Before executing Gradation adjust, be sure to perform Image Stabilization.
• It will be displayed when [Service Mode] -> [Enhanced Security] -> [Administrator Feature Level] is set to
"Level 2."
• This menu is unavailable when the key counter is not inserted while "Key Counter Only" is set by [Service
Mode] -> [Billing Setting] -> [Management Function Choice].
• The adjusted values from [Scanner Area] are also updated to the service mode as the
service mode is opened to administrators.
It will be displayed when [Service Mode] -> [Enhanced Security] -> [Administrator
Feature Level] is set to "Level 2."
• It will be displayed when [Service Mode] -> [Enhanced Security] -> [Administrator
• When the adjustment result is [Unable], confirm the orientation of the original
• It will be displayed when [Service Mode] -> [Enhanced Security] -> [Administrator Feature Level] is set to
"Level 2."
• The feature available from [Service Mode] -> [System 2] -> [User Paper Settings] is extended to
Administrator. However, the fusing temperature setting is not possible in Administrator Settings.
Function/Precondition
mode as the "Lead Edge Erase
to administrators.
mode as the "Paper Feed Direction
administrators.
"Transfer Voltage Fine
Feature Level] is set to "Level 2."
document and manually adjust the [Original Stop Position].
H-28
H UTILITY MODE > 7. Expert Adjustment
Adjustment" function in service mode is opened
Adj." function in service mode is opened to
Adj" of Service Mode up to
"Scan Area" function in
Y119930-3