Olivetti d-Color MF4003 Service Manual page 145

d-Color MF4003/MF3303
[4] [3] [1]
[5] [2] [6] [2]
9. To reinstall, reverse the order of removal.
4.7.2 Temperature/humidity sensor (TEM/HUMS1)
1. Remove the rear cover.
F.4.1.3 Rear cover
2. Open the right door.
3. Remove the IDC sensor assy.
F.4.7.1 IDC sensor (IDCS1)
4. Remove the paper feed unit.
F.4.2.6 Paper feed unit
[3]
[2] [1]
7. To reinstall, reverse the order of removal.
4.7.3 Exit path switch solenoid (SD1)
1. Remove the fusing unit.
E.3.1.12 Replacing the fusing unit
2. Remove the toner filter assy.
E.3.1.8 Replacing the toner filter
3. Remove the rear cover.
F.4.1.3 Rear cover
4. Remove the left cover.
F.4.1.2 Left cover
5. Remove the PWB box.
F.4.2.7 PWB box
6. Remove the fusing drive unit.
F.4.2.8 Fusing drive unit
[1]
Y119930-3
F DISASSEMBLY/REASSEMBLY > 4. d-Color MF4003/MF3303
6. Remove the harness from the harness guide [1].
7. Remove the two screws [2], and remove the earth plate [3].
8. Disconnect the connector [4], and remove the IDC sensor [5].
NOTE
▪ Be careful not to break the sensor head [6] of the IDC sensor.
5. Remove the screw [1].
6. Disconnect the connector [2], and remove the temperature/humidity sensor [3].
7. Remove the Lever [1].
F-47
Service Manual