Display Software_Breakpoints - HP 64746 User Manual

display software_breakpoints

This command displays the currently defined software breakpoints and their status.
If the emulation session is continued from a previous session, the listing will
include any previously defined breakpoints. The column marked "status" shows
whether the breakpoint is pending, inactivated, or unknown.
A pending breakpoint causes the processor to enter the emulation monitor upon
execution of that breakpoint. Executed breakpoints are listed as inactivated.
Entries that show an inactive status can be reactivated by executing the modify
software_breakpoints set command.
A label column also may be displayed for addresses that correspond to a symbol.
See the set command for details.
The parameters are as follows:
--EXPR-- An expression is a combination of numeric values, symbols, operators, and
parentheses, specifying an offset value for the breakpoint address. See the
--EXPR-- syntax diagram.
offset_by
This option allows you to offset the listed software breakpoint address value from
the actual address of the breakpoint. By subtracting the offset value from the
breakpoint address, the system can cause the listed address to match that given in
the assembler or compiler listing.
Examples
display software_breakpoints <RETURN>
display software_breakpoints offset_by 1000H <RETURN>
See Also The copy software_breakpoints, modify software_breakpoints, and set
commands.
Chapter 12: Emulator/Analyzer Interface Commands
display software_breakpoints
407