Table of Contents
Advertisement
Chapter 13: Error Messages
Terminal Interface Messages
661
Software breakpoint break condition is disabled
Cause: You have attempted to set or clear a software breakpoint when software
breakpoints are disabled.
Action: You must enable software breakpoints before you can set them.
663
Specified breakpoint not in list: %s
Cause: You tried to clear a software breakpoint that was not previously set. The
string %s prints the address of the breakpoint you attempted to clear.
Action: You must first set a software breakpoint before it can be cleared.
664
Breakpoint list full; not added: %s
Cause: The software breakpoint table is already reached the maximum of 32
breakpoints. The breakpoint you just requested, with address %s, was not inserted.
Action: Clear breakpoints that are no longer in use. Then, set the new breakpoint.
665
Enable breakpoint failed: %s
Cause: System failure or target condition.
Action: Check memory mapping and configuration questions.
666
Disable breakpoint failed: %s
Cause: System failure or target condition.
Action: Check memory mapping and configuration questions.
667
Breakpoint code already exists: %s
Cause: You attempted to insert a breakpoint; however, there was already a
software breakpoint instruction at that location which was not already in the
breakpoint table.
Action: Your program code is apparently using the same instructions as used by
the software breakpoints feature. Remove the breakpoint instructions from your
program code and use the modify software_breakpoints set command to insert
them.
518
Advertisement
Table of Contents
