Step 3: Run From The Transfer Address - HP 64746 User Manual

Chapter 1: Getting Started

Step 3: Run from the transfer address

Step 3: Run from the transfer address
The transfer address is the entry address defined by the software development tools
and included with the program's symbol information.
• Click on the Run Xfer til () action key.
Or, using the command line, enter:
run from transfer_address until main <RETURN>
Notice the message "Software break: <address>" is displayed on the status line and
that the emulator is "Running in monitor". When you run until an address, a
breakpoint is set at the address before the program is run.
Notice the highlighted bar on the screen; it shows the current program counter.
34