HP 64746 User Manual page 511

Action: Retry the transfer operation. If the failure is repeated, make sure that both
your host and the HP 64700 data communications parameters are configured
correctly.
401 Records expected: %s; records received: %s
Cause: The HP 64700 received a different number of records than it expected to
receive during a transfer operation.
Action: Retry the transfer. If the failure is repeated, make sure that the data
communications parameters are set correctly on the host and on the HP 64700.
410 File transfer aborted
Cause: A transfer operation was aborted due to a break received, most likely a
<CTRL>c from the keyboard.
Action: If you typed <CTRL>c, you probably did so because you thought the
transfer was about to fail. Retry the transfer, making sure to use the correct
command options. If you are unsuccessful, make sure that the data
communications parameters are set correctly on the host and on the HP 64700, then
retry the operation.
411 Severe error detected, file transfer failed
Cause: An unrecoverable error occurred during a transfer operation.
Action: Retry the transfer. If it fails again, make sure that the data
communications parameters are set correctly on the host and on the HP 64700.
Also make sure that you are using the correct command options, both on the
HP 64700 and on the host.
412 Retry limit exceeded, transfer failed
Cause: The limit for repeated attempts to send a record during a transfer operation
was exceeded, therefore the transfer was aborted.
Action: Retry the transfer. Make sure you are using the correct command options
for both the host and the HP 64700. The data communications parameters need to
be set correctly for both devices. Also, if you are in a remote location from the
host, it is possible that line noise may cause the failure.
Chapter 13: Error Messages
Terminal Interface Messages
511