Configuring The Emulator Pod - HP 64746 User Manual

Configuring the Emulator Pod

In order to configure the emulator pod, you must first start the configuration
interface and access the "Emulator Pod Settings" configuration section (refer to the
previous "Using the Configuration Interface" section).
This section shows you how to:
•
Enable/disable bus arbitration.
•
Specify the analyzer's response to bus arbitration.
•
Enable/disable emulation memory synchronization.
•
Enable/disable /BERR connection to target system.
•
Enable/disable response to target system interrupts.
•
Select the normal or dedicated interrupt mode.
•
Set the reset value of the Supervisor Stack Pointer.
•
Set the processor data bus width.
•
Set the target system memory access size.
•
Select /IACK7 or PB0.
•
Drive background cycles to the target system.
•
Stop driving background cycles to the target system.
•
Specify /DTACK sources for chip selects.
Chapter 4: Configuring the Emulator
Configuring the Emulator Pod
127