HP 64746 User Manual page 520

Chapter 13: Error Messages
Terminal Interface Messages
Action: Check memory mapping and configuration questions.
689 Break due to cause other than step
Cause: An activity other than a step command caused the emulator to break. This
could include any of the break conditions or a <CTRL>c break.
692 Trace error during CMB execute
Cause: System failure.
Action: Run performance verification (Terminal Interface pv command).
693 CMB execute; run started
Cause: This status message is displayed when you are making coordinated
measurements. The CMB /EXECUTE pulse has been received; the emulation
processor started running at the address specified by the specify run command.
Action: None; information only.
694
Run failed during CMB execute
Cause: System failure or target condition.
Action: Run performance verification (Terminal Interface pv command), and
check target system.
700 Target memory access failed
Cause: This message is displayed if the emulator was unable to perform the
requested operation on memory mapped to the target system.
Action: In most cases, the problem results from the emulator's inability to break to
the monitor to perform the operation. See message 608.
702
Emulation memory access failed
Cause: System failure.
Action: Run performance verification (Terminal Interface pv command).
520