Table of Contents
Advertisement
Chapter 13: Error Messages
Terminal Interface Messages
413
Transfer failed to start
Cause: Communication link or transfer protocol incorrect.
Action: Check link and transfer options.
415
Timeout, receiver failed to respond
Cause: Communication link or transfer protocol incorrect.
Action: Check link and transfer options.
600
Adjust PC failed during break
Cause: System failure or target condition.
Action: Run performance verification (Terminal Interface pv command), and
check target system.
602
Break failed
Cause: The break command was unable to break the emulator to the monitor.
Action: Determine why the break failed, then correct the condition and retry the
command. See message 608.
603
Read PC failed during break
Cause: System failure or target condition.
Action: Try again.
604
Disable breakpoint failed: %s
Cause: System failure or target condition.
Action: Run performance verification (Terminal Interface pv command), and
check target system.
605
Undefined software breakpoint: %s
Cause: The emulator has encountered a software breakpoint in your program that
was not inserted with the modify software_breakpoints set command.
Action: Remove the breakpoint instructions in your code before assembly and link.
512
Advertisement
Table of Contents
