HP 64746 User Manual page 519

668
Breakpoint not added: %s
Cause: You tried to insert a breakpoint in a memory location which was not
mapped or was mapped as guarded memory.
Action: Insert breakpoints only within memory ranges mapped to emulation or
target RAM or ROM.
669
Breakpoint remove aborted
Cause: Occurs when <CTRL>c is entered when clearing a software breakpoint.
670 Breakpoint enable aborted
Cause: Occurs when <CTRL>c is entered when setting software breakpoints.
671
Breakpoint disable aborted
Cause: Occurs when <CTRL>c is entered when disabling software breakpoints.
680
Stepping failed
Cause: Stepping has failed for some reason.
Action: Usually, this error message will occur with other error messages. Refer to
the descriptions of the accompanying error messages to find out more about why
stepping failed.
684
Failed to disable step mode
Cause: System failure.
Action: Run performance verification (Terminal Interface pv command).
686
Stepping aborted; number steps completed: %d
Cause: This message is displayed if a break was received during a step command
with a step count greater than zero. The break could have been due to any of the
break conditions or a <CTRL>c break. The number of steps completed is displayed.
688
Step display failed
Cause: System failure or target condition.
Chapter 13: Error Messages
Terminal Interface Messages
519